Tips & Tricks: Assembly Panelization


Reading time ( words)

Thoughtful PCB array and panel design can reduce line stoppage, improve changeover time and reduce material scrap. For the purpose of this discussion, a panel is an array of PCBs which may or may not include scrap material.

Fiducial location and design are good aids to prevent mistakes, but may still result in line stoppage. In this figure, the round features with square mask perimeter are fiducials. The square feature with round mask is a PCB bad mark.

Horky-Jan2018-Fig1.jpg

Figure 1: A simple panel array of the top side and the mirrored horizontal view of bottom side components if applicable.

If you have fiducial recognition issues, making the shape of the mask opening different than the fiducial feature may help the vision system discern the target feature easier. Locating the bad mark at the PCB center consistently helps the line operator identify the bad mark without supporting drawings and reduces camera movement. Locating fiducials off center of the PCB will help prevent a print and/or place error but it will still stop the line upon the error.

Horky-Jan2018-Fig2.jpg

Figure 2: The scored PCB array with the top row rotated 180°.

Horky-Jan2018-Fig3.jpg

Figure 3: One row with top-side up and the second row mirrored vertically.

Horky-Jan2018-Fig4.jpg

Figure 4: An array with a combination of mirroring and rotations. Within the four PCB orientations are the top side mirrored horizontally and vertically.

Share


Suggested Items

Tempo Automation's Open House Raises the Curtain in San Francisco

11/28/2018 | Nolan Johnson, I-Connect007
Based in San Francisco, Tempo Automation specializes in rapid PCB assembly and on low volume production for a wide range of board complexities. It recently held an open house at its brand-new facility in the South of Market (SoMa) district—which is normally restricted under customer non-disclosure agreements as well as International Traffic in Arms Regulations (ITAR) regulations—to customers, vendors, local designers, and government officials.

A Look at Our Readers’ Manufacturing Challenges

11/21/2018 | Stephen Las Marias, I-Connect007
In a recent SMT007 survey, we asked the following question: "What are your greatest challenges when it comes to soldering?" Here are just a few of the replies, slightly edited for clarity.

Solder Paste Jetting: An Integral Approach

11/21/2018 | Jeff Leal, Gustaf Mårtensson, and Nerijus Augustis, Mycronic AB
Solder paste jetting is a technique that differs greatly from traditional solder paste deposition methods. In this article, solder paste jetting is compared with the other solder paste deposition methods—solder paste dispensing and solder paste printing and solder paste jetting—and highlights why it is becoming a viable option and how it increases the flexibility of a single production system.



Copyright © 2018 I-Connect007. All rights reserved.