Soldering to Magnet Wires with 50In50Pb Alloy


Reading time ( words)

Posted by Derrick Herron on Monday, October 20, 2014



The Indium Corporation recently had a customer contact us looking for 50In50Pb solder wire.  We manufacture large amounts of this indium-lead material as it is used in numerous applications.  In this case, it was the application that was quite interesting.  I won’t give any customer information, but will say that a report by Hughes Aircraft was brought to our attention.  It can be found online here. The report deals with the bonding of extremely thin copper wire (down to 0.0004” in diameter!) to thicker, more resilient wire.spool_indium.jpg

Through the work done in the above-mentioned paper, it was found that the 50In50Pb formed the strongest bond of the alloys tested and was very limited in its consumption of the copper wire when manufacturing times and temperatures were carefully observed. I was sure to caution our customer that indium and copper will form a brittle intermetallic layer, as my colleague Eric Bastow explains here. However, Eric also points out that this type of solder joint is created every day in applications where it does not cause a problem to the end product. In any application, reliability testing should be done to ensure that the final product exceeds the needs of the environment in which it will be used.  We were curious if more people out there are using indium-lead solder alloys in this type of application.The thicker wire is able to withstand the stresses placed on it in a subsequent encapsulation step, whereas the thin copper wire would break during this step, therefore making the thicker material necessary.  One problem that quickly arose was that if traditional tin-based solders were used to bond these two wires together, they would very rapidly consume the thin copper wire, resulting in an extremely weak interface - if an interface survived at all.  An alternate solder was needed and 50In50Pb was my recommendation.

Please send me a message if you’re doing this type of work or if you’re interested in using our indium-lead alloys for this or any other application. -Derrick

derrick_herron.jpg 

Derrick Herron

Contact Derrick

315-853-4900 x7599

Capture-derrickbuttons.JPG

Share




Suggested Items

Passing the Test With SMTA’s Rob Boguski

09/14/2022 | Andy Shaughnessy, I-Connect007
I recently spoke with Rob Boguski, president of Fremont, California-based Datest and an SMTA vice president and board member. Rob explained why today’s test customers are asking for more information than the traditional pass/fail, offers a preview of SMTA International, and gives an update on SMTA’s planning strategy for the next five years.

Four Silver Linings in the Stormy Clouds of Pandemic, Supply Chain, and Inflation

09/14/2022 | Dr. Ronald C. Lasky, Indium Corp.
It may be difficult to see any bright spots in the current and recent economic situation. We have all experienced the devastation of the pandemic, supply chain issues, and most recently, inflation. However, as a senior technologist for an international materials supplier (Indium Corporation) and a professor of engineering at an Ivy League research university (Dartmouth College), I offer these four silver linings for those of us in the electronics industry.

Solder Paste Printing and Optimizations for Interconnecting Back Contact Cells

07/26/2022 | Narahari S Pujari and Krithika PM, MacDermid Alpha Electronics Solutions
The interdigitated back contact (IBC) is one of the methods to achieve rear contact solar cell interconnection. The contact and interconnection via rear side theoretically achieve higher efficiency by moving all the front contact grids to the rear side of the device. This results in all interconnection structures being located behind the cells, which brings two main advantages. First, there is no frontside shading of the cell by the interconnection ribbons, thus eliminating the need for trading off series resistance, losses for shading losses when using larger interconnection ribbons. Second, a more homogeneous looking frontside of the solar module enhances the aesthetics.



Copyright © 2022 I-Connect007. All rights reserved.