High-reliability, Pb-free, Halogen-free Solder


Reading time ( words)

Abstract

With increasing demand for the use of Pb-free solder materials coupled with an increasing requirement for halogen-free solder paste formulations, some market sectors are experiencing several challenges using standard SnAgCu (SAC) halide-free solder materials, especially in electronic assemblies for automotive products experiencing harsh operating environments such as high operating temperatures, increased thermal cycling conditions, high levels of vibration and contact with liquids such as moisture and lubricants. For example, in automotive "under the hood" conditions, temperatures easily exceed 125°C and can cycle lower than -20°C. The reliability required to survive these harsh conditions is often greater than standard SAC solders can provide. In this paper, the performance of a specifically designed Pb-free solder alloy for increased reliability in high-temperature thermal cycling is discussed.

Reliability can also be impacted by no-clean post reflow residues adjacent to solder joints. These may potentially interact with other surface materials causing corrosion issues or lower insulation resistance. With halogen-free electronic assemblies arguably becoming more favourable than halide-free–even within some automotive manufacturers–solder paste manufacturers are now faced with the challenge of formulating halogen-free fluxes which can also demonstrate high reliability. While removing the halogen from a material is not difficult, replacing it with an activator set that can deliver a wide reflow process window whilst retaining or increasing reliability is a significant challenge. The paper also documents the challenges and breakthroughs in developing halogen-free or zero-halogen solder fluxes that are compatible with the Pb-free alloy specifically designed for higher reliability.

Introduction

Reliability testing of standard SAC-based alloys as a direct comparison to Pb-containing materials as a response to the implementation of the RoHS directive during the mid-2000s has been well documented. The results of the testing broadly concluded that little differences could be seen between SAC and SnPb alloys. Analysis of the data showed that, depending on the test vehicle configuration and the test conditions in some cases, SAC alloys gave improved reliability over SnPb alloys and in other examples the reverse result occurred. This testing focused on environmental conditions representative of the bulk of the electronics industry at that moment in time (-40°C to +125°C). 

Read the full article here.


Editor's Note: This article originally appeared in the November 2014 issue of SMT Magazine.

Share

Print


Suggested Items

Real Time with…SMTAI 2020: KYZEN on How Maximized Stencil Life Improves Yields

09/16/2020 | Real Time with...SMTAI
KYZEN Executive Vice President Tom Forsythe shares company updates on stencil cleaning with Nolan Johnson. KYZEN recently announced its newest stencil cleaning product—KYZEN E5631. Forsythe details how the product is best used, as well as the benefits it brings to maximizing stencil life and improving manufacturing yields.

Just Ask Eric: Selecting the Right Lead-Free Solder for Your Application

09/15/2020 | I-Connect007 Editorial Team
First, we asked you to send in your questions for Happy Holden and Joe Fjelstad in our “Just Ask” series. Now, it’s Eric Camden’s turn! A regular SMT007 columnist, Eric is a lead investigator at Foresite Inc., an analytical testing and consulting laboratory. As a reliability expert, Eric has worked with many large OEMs and contract manufacturing companies to optimize their manufacturing processes and assist with the identification of electronic hardware failures utilizing various analytical techniques. He also specializes in optimizing PCBA processes and identifying hardware failures through analysis. We hope you enjoy “Just Ask Eric.”

Just Ask Joe: The Occam Process

08/25/2020 | I-Connect007 Editorial Team
First, we asked you to send in your questions for Happy Holden. Now, it’s Joe Fjelstad’s turn! Inventor, columnist, instructor, and founder of Verdant Electronics, Joe has been involved with rigid PCBs and flexible circuits for decades, and he’s ready to share some of his knowledge with our readers. We hope you enjoy “Just Ask Joe.”



Copyright © 2020 I-Connect007. All rights reserved.